Lines Matching +full:smp +full:- +full:offset
1 # SPDX-License-Identifier: GPL-2.0
81 <http://www.linux-sh.org/>.
95 depends on SMP && PREEMPTION
213 prompt "Processor sub-type selection"
219 # SH-2 Processor Support
230 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
232 # SH-2A Processor Support
278 bool "Support MX-G processor"
282 Select MX-G if running on an R8A03022BG part.
284 # SH-3 Processor Support
294 Select SH7706 if you have a 133 Mhz SH-3 HD6417706 CPU.
300 Select SH7707 if you have a 60 Mhz SH-3 HD6417707 CPU.
306 Select SH7708 if you have a 60 Mhz SH-3 HD6417708S or
307 if you have a 100 Mhz SH-3 HD6417708R CPU.
313 Select SH7709 if you have a 80 Mhz SH-3 HD6417709 CPU.
320 Select SH7710 if you have a SH3-DSP SH7710 CPU.
327 Select SH7712 if you have a SH3-DSP SH7712 CPU.
337 Select SH7720 if you have a SH3-DSP SH7720 CPU.
346 Select SH7721 if you have a SH3-DSP SH7721 CPU.
348 # SH-4 Processor Support
354 Select SH7750 if you have a 200 Mhz SH-4 HD6417750 CPU.
360 Select SH7091 if you have an SH-4 based Sega device (such as
375 Select SH7751 if you have a 166 Mhz SH-4 HD6417751 CPU,
386 # SH-4A Processor Support
397 Select SH7723 if you have an SH-MobileR2 CPU.
408 Select SH7724 if you have an SH-MobileR2R CPU.
454 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
460 bool "Support SH-X3 processor"
463 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
467 # SH4AL-DSP Processor Support
564 than the panic-ed kernel.
566 config SMP config
567 bool "Symmetric multi-processing support"
574 If you say N here, the kernel will run on uni- and multiprocessor
583 See also <file:Documentation/admin-guide/lockup-watchdogs.rst> and the SMP-HOWTO
589 int "Maximum number of CPUs (2-32)"
591 depends on SMP
599 This is purely to save memory - each supported CPU adds
603 bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
604 depends on SMP
611 depends on !SMP
614 This is the default implementation for both UP and non-ll/sc
624 bool "Implement atomic operations by roll-back (gRB) (EXPERIMENTAL)"
628 atomic operations using a software implementation of load-locked/
629 store-conditional (LLSC). On machines which do not have hardware
675 This sets the default offset of zero page.
686 This option allows you to set the link address offset of the zImage.