dts/qcom/pm8916.dtsi

1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/input/linux-event-codes.h>
4 #include <dt-bindings/interrupt-controller/irq.h>
5 #include <dt-bindings/spmi/spmi.h>
10 		compatible = "qcom,pm8916", "qcom,spmi-pmic";
12 		#address-cells = <1>;
13 		#size-cells = <0>;
16 			compatible = "qcom,pm8916-pon";
18 			mode-bootloader = <0x2>;
19 			mode-recovery = <0x1>;
22 				compatible = "qcom,pm8941-pwrkey";
25 				bias-pull-up;
30 				compatible = "qcom,pm8941-resin";
33 				bias-pull-up;
38 				compatible = "qcom,pm8916-wdt";
40 				timeout-sec = <60>;
45 			compatible = "qcom,pm8916-lbc";
47 			reg-names = "chgr", "bat_if", "usb", "misc";
59 			interrupt-names = "vbat_det",
73 		pm8916_usbin: usb-detect@1300 {
74 			compatible = "qcom,pm8941-misc";
77 			interrupt-names = "usb_vbus";
81 		pm8916_temp: temp-alarm@2400 {
82 			compatible = "qcom,spmi-temp-alarm";
85 			io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
86 			io-channel-names = "thermal";
87 			#thermal-sensor-cells = <0>;
91 			compatible = "qcom,spmi-vadc";
94 			#address-cells = <1>;
95 			#size-cells = <0>;
96 			#io-channel-cells = <1>;
100 				qcom,pre-scaling = <1 10>;
104 				qcom,pre-scaling = <1 3>;
124 			compatible = "qcom,pm8916-bms-vm";
132 			interrupt-names = "cv_leave",
143 			compatible = "qcom,pm8941-rtc";
145 			reg-names = "rtc", "alarm";
150 			compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
152 			gpio-controller;
153 			#gpio-cells = <2>;
154 			gpio-ranges = <&pm8916_mpps 0 0 4>;
155 			interrupt-controller;
156 			#interrupt-cells = <2>;
160 			compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
162 			gpio-controller;
163 			gpio-ranges = <&pm8916_gpios 0 0 4>;
164 			#gpio-cells = <2>;
165 			interrupt-controller;
166 			#interrupt-cells = <2>;
171 		compatible = "qcom,pm8916", "qcom,spmi-pmic";
173 		#address-cells = <1>;
174 		#size-cells = <0>;
177 			compatible = "qcom,pm8916-pwm";
179 			#pwm-cells = <2>;
185 			compatible = "qcom,pm8916-vib";
190 		pm8916_codec: audio-codec@f000 {
191 			compatible = "qcom,pm8916-wcd-analog-codec";
193 			interrupt-parent = <&spmi_bus>;
208 			interrupt-names = "cdc_spk_cnp_int",
222 			#sound-dai-cells = <1>;