dts/freescale/imx8mp-venice-gw71xx.dtsi

1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/leds/common.h>
8 #include <dt-bindings/phy/phy-imx8-pcie.h>
12 		compatible = "gpio-usb-b-connector", "usb-b-connector";
13 		pinctrl-names = "default";
14 		pinctrl-0 = <&pinctrl_usbcon1>;
16 		label = "Type-C";
17 		id-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
21 				remote-endpoint = <&usb3_dwc>;
26 	led-controller {
27 		compatible = "gpio-leds";
28 		pinctrl-names = "default";
29 		pinctrl-0 = <&pinctrl_gpio_leds>;
31 		led-0 {
35 			default-state = "on";
36 			linux,default-trigger = "heartbeat";
39 		led-1 {
43 			default-state = "off";
47 	pcie0_refclk: clock-pcie0 {
48 		compatible = "fixed-clock";
49 		#clock-cells = <0>;
50 		clock-frequency = <100000000>;
54 		compatible = "pps-gpio";
55 		pinctrl-names = "default";
56 		pinctrl-0 = <&pinctrl_pps>;
62 /* off-board header */
64 	pinctrl-names = "default";
65 	pinctrl-0 = <&pinctrl_spi2>;
66 	cs-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>;
71 	gpio-line-names =
83 	clock-frequency = <400000>;
84 	pinctrl-names = "default";
85 	pinctrl-0 = <&pinctrl_i2c2>;
91 		pinctrl-names = "default";
92 		pinctrl-0 = <&pinctrl_accel>;
93 		st,drdy-int-pin = <1>;
94 		interrupt-parent = <&gpio4>;
100 	fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
101 	fsl,clkreq-unsupported;
103 	clock-names = "ref";
108 	pinctrl-names = "default";
109 	pinctrl-0 = <&pinctrl_pcie0>;
110 	reset-gpio = <&gpio4 29 GPIO_ACTIVE_LOW>;
116 	pinctrl-names = "default";
117 	pinctrl-0 = <&pinctrl_uart1>;
121 /* off-board header */
123 	pinctrl-names = "default";
124 	pinctrl-0 = <&pinctrl_uart3>;
128 /* USB1 Type-C front panel */
130 	pinctrl-names = "default";
131 	pinctrl-0 = <&pinctrl_usb1>;
132 	fsl,over-current-active-low;
141 	/* dual role is implemented but not a full featured OTG */
142 	adp-disable;
143 	hnp-disable;
144 	srp-disable;
146 	usb-role-switch;
147 	role-switch-default-mode = "peripheral";
152 			remote-endpoint = <&usb_dr_connector>;
157 /* USB2 - MiniPCIe socket */
159 	fsl,permanently-attached;
160 	fsl,disable-port-power-control;
174 	pinctrl-names = "default";
175 	pinctrl-0 = <&pinctrl_hog>;