nxp/imx/imx53-smd.dts

1 // SPDX-License-Identifier: GPL-2.0+
6 /dts-v1/;
7 #include <dt-bindings/input/input.h>
12 	compatible = "fsl,imx53-smd", "fsl,imx53";
19 	gpio-keys {
20 		compatible = "gpio-keys";
22 		key-volume-up {
23 			label = "Volume Up";
28 		key-volume-down {
29 			label = "Volume Down";
37 	pinctrl-names = "default";
38 	pinctrl-0 = <&pinctrl_esdhc1>;
39 	cd-gpios = <&gpio3 13 GPIO_ACTIVE_LOW>;
40 	wp-gpios = <&gpio4 11 GPIO_ACTIVE_HIGH>;
45 	pinctrl-names = "default";
46 	pinctrl-0 = <&pinctrl_esdhc2>;
47 	non-removable;
52 	pinctrl-names = "default";
53 	pinctrl-0 = <&pinctrl_uart3>;
54 	uart-has-rtscts;
59 	pinctrl-names = "default";
60 	pinctrl-0 = <&pinctrl_ecspi1>;
61 	cs-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>, <&gpio3 19 GPIO_ACTIVE_LOW>;
66 		spi-max-frequency = <8000000>;
71 		#address-cells = <1>;
72 		#size-cells = <1>;
73 		compatible = "st,m25p32", "jedec,spi-nor";
74 		spi-max-frequency = <20000000>;
78 			label = "U-Boot";
80 			read-only;
91 	pinctrl-names = "default";
92 	pinctrl-0 = <&pinctrl_esdhc3>;
93 	non-removable;
98 	pinctrl-names = "default";
99 	pinctrl-0 = <&pinctrl_hog>;
101 	imx53-smd {
103 			fsl,pins = <
115 			fsl,pins = <
123 			fsl,pins = <
134 			fsl,pins = <
145 			fsl,pins = <
160 			fsl,pins = <
175 			fsl,pins = <
182 			fsl,pins = <
189 			fsl,pins = <
206 			fsl,pins = <
214 			fsl,pins = <
221 			fsl,pins = <
228 			fsl,pins = <
239 	pinctrl-names = "default";
240 	pinctrl-0 = <&pinctrl_uart1>;
245 	pinctrl-names = "default";
246 	pinctrl-0 = <&pinctrl_uart2>;
251 	pinctrl-names = "default";
252 	pinctrl-0 = <&pinctrl_i2c2>;
272 	pinctrl-names = "default";
273 	pinctrl-0 = <&pinctrl_i2c1>;
284 		pinctrl-names = "default";
285 		pinctrl-0 = <&pinctrl_ov5642>;
286 		assigned-clocks = <&clks IMX5_CLK_SSI_EXT1_SEL>,
288 		assigned-clock-parents = <&clks IMX5_CLK_PLL2_SW>,
290 		assigned-clock-rates = <0>, <24000000>;
292 		clock-names = "xclk";
293 		DVDD-supply = <&ldo9_reg>;
294 		AVDD-supply = <&ldo7_reg>;
295 		reset-gpios = <&gpio6 9 GPIO_ACTIVE_LOW>;
296 		powerdown-gpios = <&gpio6 10 GPIO_ACTIVE_HIGH>;
300 				remote-endpoint = <&ipu_csi0_from_parallel_sensor>;
301 				bus-width = <8>;
302 				hsync-active = <1>;
303 				vsync-active = <1>;
311 		interrupt-parent = <&gpio7>;
316 				regulator-min-microvolt = <1200000>;
317 				regulator-max-microvolt = <3600000>;
321 				regulator-min-microvolt = <1250000>;
322 				regulator-max-microvolt = <3650000>;
329 	pinctrl-names = "default";
330 	pinctrl-0 = <&pinctrl_fec>;
331 	phy-mode = "rmii";
332 	phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
337 	remote-endpoint = <&ov5642_to_ipu_csi0>;
338 	data-shift = <12>; /* Lines 19:12 used */
339 	hsync-active = <1>;
340 	vsync-active = <1>;
344 	pinctrl-names = "default";
345 	pinctrl-0 = <&pinctrl_ipu_csi0>;