Lines Matching +full:sub +full:- +full:block

10 reset consumer (the module being reset, or a module managing when a sub-
15 specifier - a list of DT cells that represents the reset signal within the
23 the DT node of each affected HW block, since if activated, an unrelated block
27 block node for dedicated reset signals. The intent of this binding is to give
30 block.
35 #reset-cells:	Number of cells in a reset specifier; Typically 0 for nodes
41 	rst: reset-controller {
42 		#reset-cells = <1>;
51 		#reset-cells, then only the phandle portion of the pair will
55 reset-names:	List of reset signal name strings sorted in the same order as
56 		the resets property. Consumers drivers will use reset-names to
63 		reset-names = "reset";
70 		reset-names = "i2s1", "i2s2", "dma", "mixer";
73 This represents a bus that controls the reset signal of each of four sub-