Lines Matching +full:default +full:- +full:on
1 # SPDX-License-Identifier: GPL-2.0-only
7 default y if ARCH_HAS_RESET_CONTROLLER
12 via GPIOs or SoC-internal reset controller modules.
20 depends on MFD_ALTERA_A10SR || COMPILE_TEST
23 peripheral PHYs on the Altera Arria10 System Resource Chip.
27 default ATH79
34 default ARC_PLAT_AXS10X
40 depends on BMIPS_GENERIC || COMPILE_TEST
41 default BMIPS_GENERIC
47 depends on ARCH_BERLIN || COMPILE_TEST
48 default m if ARCH_BERLIN
54 depends on ARCH_BRCMSTB || COMPILE_TEST
55 default ARCH_BRCMSTB
62 depends on HAS_IOMEM
63 depends on ARCH_BRCMSTB || COMPILE_TEST
64 default ARCH_BRCMSTB
66 This enables the RESCAL reset controller for SATA, PCIe0, or PCIe1 on
71 depends on MACH_EYEQ5 || MACH_EYEQ6H || COMPILE_TEST
73 default MACH_EYEQ5 || MACH_EYEQ6H
84 depends on GPIOLIB
87 GPIOs. Typically for OF platforms this driver expects "reset-gpios"
90 If compiled as module, it will be called reset-gpio.
94 depends on HAS_IOMEM
95 depends on ARC_SOC_HSDK || COMPILE_TEST
101 depends on IMX_SCU && HAVE_ARM_SMCCC
102 depends on (ARM64 && ARCH_MXC) || COMPILE_TEST
108 depends on HAS_IOMEM
109 depends on SOC_IMX7D || (ARM64 && ARCH_MXC) || COMPILE_TEST
110 default y if SOC_IMX7D
117 depends on ARCH_MXC || COMPILE_TEST
119 default CLK_IMX8MP
125 depends on X86 || COMPILE_TEST
126 depends on OF && HAS_IOMEM
135 depends on (SOC_CANAAN_K210 || COMPILE_TEST) && OF
137 default SOC_CANAAN_K210
139 Support for the Canaan Kendryte K210 RISC-V SoC reset controller.
145 default SOC_TYPE_XWAY
151 default ARCH_LPC18XX
157 depends on ARCH_SPARX5 || SOC_LAN966 || MCHP_LAN966X_PCI || COMPILE_TEST
158 default y if SPARX5_SWITCH
165 default ARCH_NPCM
173 depends on ARCH_MA35 || COMPILE_TEST
174 default ARCH_MA35
180 depends on MIPS || COMPILE_TEST
186 depends on MCHP_CLK_MPFS
188 default MCHP_CLK_MPFS
194 depends on ARCH_QCOM || COMPILE_TEST
196 This enables the AOSS (always on subsystem) reset driver
203 depends on ARCH_QCOM || COMPILE_TEST
212 depends on RASPBERRYPI_FIRMWARE || (RASPBERRYPI_FIRMWARE=n && COMPILE_TEST)
213 default USB_XHCI_PCI
215 Raspberry Pi 4's co-processor controls some of the board's HW
218 interfacing with RPi4's co-processor and model these firmware
223 depends on ARCH_RZG2L || COMPILE_TEST
225 Support for USBPHY Control found on RZ/G2L family. It mainly
230 depends on ARM_SCMI_PROTOCOL || COMPILE_TEST
231 default ARM_SCMI_PROTOCOL
241 …default ARCH_ASPEED || ARCH_BCMBCA || ARCH_BITMAIN || ARCH_REALTEK || ARCH_SOPHGO || ARCH_STM32 ||…
242 depends on HAS_IOMEM
249 - Altera SoCFPGAs
250 - ASPEED BMC SoCs
251 - Bitmain BM1880 SoC
252 - Realtek SoCs
253 - RCC reset controller in STM32 MCUs
254 - Allwinner SoCs
255 - SiFive FU740 SoCs
256 - Sophgo SoCs
260 default ARM && ARCH_INTEL_SOCFPGA
268 default ARCH_SUNPLUS
277 default ARCH_SUNXI
283 tristate "TI System Control Interface (TI-SCI) reset driver"
284 depends on TI_SCI_PROTOCOL || (COMPILE_TEST && TI_SCI_PROTOCOL=n)
287 available on some new TI's SoCs. If you wish to use reset resources
292 depends on HAS_IOMEM
296 memory-mapped reset registers as part of a syscon device node. If
297 you wish to use the reset framework for such memory-mapped devices,
310 depends on MFD_TN48M_CPLD || COMPILE_TEST
311 default MFD_TN48M_CPLD
314 It provides reset signals for Armada 7040 and 385 SoC-s, Alleycat 3X
315 switch MAC-s, Alaska OOB ethernet PHY, Quad Alaska ethernet PHY-s and
319 called reset-tn48m.
323 depends on ARCH_UNIPHIER || COMPILE_TEST
324 depends on OF && MFD_SYSCON
325 default ARCH_UNIPHIER
327 Support for reset controllers on UniPhier SoCs.
333 depends on (ARCH_UNIPHIER || COMPILE_TEST) && OF
334 default ARCH_UNIPHIER
338 on UniPhier SoCs. Say Y if you want to control reset signals
343 default ARCH_ZYNQ
349 default ARCH_ZYNQMP