Lines Matching +full:tx +full:- +full:output +full:- +full:config

1 # SPDX-License-Identifier: GPL-2.0-only
6 config IPW2100
32 	  rather than built-in (Y). This driver requires firmware at device
33 	  initialization time, and when built-in this typically happens
39 config IPW2100_MONITOR
48 config IPW2100_DEBUG
49 	bool "Enable full debugging output in IPW2100 module."
52 	  This option will enable debug tracing output for the IPW2100.
55 	  control which debug output is sent to the kernel log by setting the
65 config IPW2200
91 	  rather than built-in (Y). This driver requires firmware at device
92 	  initialization time, and when built-in this typically happens
98 config IPW2200_MONITOR
107 config IPW2200_RADIOTAP
111 config IPW2200_PROMISCUOUS
127 	    % tethereal -i rtap0
135 config IPW2200_QOS
139 config IPW2200_DEBUG
140 	bool "Enable full debugging output in IPW2200 module."
143 	  This option will enable low level debug tracing output for IPW2200.
146 	  debug option enables debug on hot paths (e.g Tx, Rx, ISR) and
152 config LIBIPW
165 config LIBIPW_DEBUG
166 	bool "Full debugging output for the LIBIPW component"
169 	  This option will enable debug tracing output for the
173 	  can control which debug output is sent to the kernel log by