iio/adc/pac1921.c

33 /* pac1921 integration configuration bits */
64 /* Time from Sleep State to Start of Integration Period (tSLEEP_TO_INT) */
116  * integration period.
118  * Changing the number of samples affects the integration period: higher the
119  * number of samples, longer the integration period.
128  * The integration period depends on the configuration of number of integration
130  * contains integration periods, in microsecs unit, based on table 4-5 from
131  * datasheet considering power integration mode, 14-Bit resolution and post
218  * Check if first integration after configuration update has completed.
231 		 * Data valid after the device entered into integration state,  in pac1921_data_ready()
233 		 * and completed the first integration period.  in pac1921_data_ready()
432 		 * The integration period depends on the number of integration  in pac1921_read_raw()
464  * write the config register and set the device back into integration state.
465  * Also reset integration start time and mark first integration to be yet
484 	/* Re-enable integration */  in pac1921_update_cfg_reg()
491 	 * Reset integration started time and mark this integration period as  in pac1921_update_cfg_reg()
493 	 * only at the end of this integration period.  in pac1921_update_cfg_reg()
604  * Update the device with the given number of integration samples.
1057  * integration state.
1081 	 * Configure integration:  in pac1921_init()
1082 	 * - num of integration samples  in pac1921_init()
1096 	 * - VPower free run integration mode  in pac1921_init()
1106 	/* Enable integration */  in pac1921_init()
1173 …s/aemDocuments/documents/OTH/ApplicationNotes/ApplicationNotes/PAC193X-Integration-Notes-for-Micro…