Lines Matching full:will

35 After that, you will have the device listening. Reading will return a single
55 DELAY is a generic parameter which will delay the execution of the test in CMD.
56 While a command is running (including the delay), new commands will not be
59 The commands are described in the following section. An invalid command will
89 access the bus at the same time, the bus will be busy. Example to read 128
110 Also needs master mode. This test will send an SMBUS_HOST_NOTIFY message to the
133     - 0x01 (i.e. one further byte will be written)
137 Partial command. This test will respond to a block process call as defined by
139 will be sent back in the following read transfer. Note that in this read
140 transfer, the testunit will prefix the length of the bytes to follow. So, if
167 Partial command. After sending this command, the testunit will reply to a read
170 128 bytes. However, it will only respond if the read message is connected to
172 repeated start correctly, this will work::
182 STOP/START combinations between the two messages will *not* work because they
213 The following command will trigger the alert with a response of 0xc9 after 1
230 If the host does not respond to the alert within 1 second, the test will be
231 aborted and the testunit will report an error.
233 For this test, the testunit will shortly drop its assigned address and listen
234 on the SMBus Alert Response Address (0x0c). It will reassign its original