Lines Matching full:signal

102 			The output signal is initially low, and will remain low
103 			until the counter reaches zero. The output signal then
108 			The output signal is initially high. The output signal
109 			will go low by a trigger input signal, and will remain
113 			value and setting the output signal low, thus starting
117 			The output signal is initially high. When the counter
118 			has decremented to 1, the output signal goes low for one
119 			clock pulse. The output signal then goes high again, the
124 			The output signal is initially high.
128 			expires, the output signal changes value and the
135 			the count expires, the output signal goes low and the
143 			The output signal is initially high. When the count
149 			The output signal is initially high. Counting is started
150 			by a trigger input signal. When the count expires, the
151 			output signal will go low for one clock pulse and then
216 			Rising edges on signal A updates the respective count.
217 			The input level of signal B determines direction.
221 			signal A updates the respective count; if the direction
222 			is backward, falling edges on quadrature pair signal A
228 			signal B updates the respective count; if the direction
229 			is backward, falling edges on quadrature pair signal B
234 			Any state transition on quadrature pair signal A updates
239 			Any state transition on quadrature pair signal B updates
285 		Action mode of Count Y for Signal Z. This attribute indicates
286 		the condition of Signal Z that triggers the count function
291 			Signal does not trigger the count function. In
292 			Pulse-Direction count function mode, this Signal is
383 		for the respective channel of Signal Y. Valid attribute values
392 		respective channel of Signal Y is enabled. Valid attribute
399 		Filter clock factor for input Signal Y. This prescaler value
406 		Active level of index input Signal Y; irrelevant in
414 		Discrete set of available values for the respective Signal Y
421 		Active level of Signal Y. The following polarity values are
425 			Signal high state considered active level (rising edge).
428 			Signal low state considered active level (falling edge).
435 		Signal Y. If possible, this should match the name of the
436 		respective signal as it appears in the device datasheet.
438 What:		/sys/bus/counter/devices/counterX/signalY/signal
442 		Signal level state of Signal Y. The following signal level
455 		Configure the counter associated with Signal Y for
477 		Read-only attribute that indicates the signal Y frequency, in Hz.