ath/ath10k/rx_desc.h

53  *		Indicates the first MSDU of the PPDU.  If both first_mpdu
61  *		Indicates the last MSDU of the last MPDU of the PPDU.  The
71  *		Indicates no matching entries within the the max search
75  *		Indicates an unsuccessful search for the peer index due to
87  *		Set if frame type indicates either null data or QoS null
111  *		Indicates that this is an 802.11 fragment frame.  This is
121  *		Indicates that this status has a corresponding MSDU that
134  *		Indicates that the MSDU length from the 802.3 encapsulated
138  *		Indicates that the computed checksum (tcp_udp_chksum) did
142  *		Indicates that the computed checksum did not match the
146  *		Indicates no matching entry was found in the address search
150  *		Indicates no matching entry was found in the address search
154  *		Indicates an unsuccessful search for the source MAC address
158  *		Indicates an unsuccessful search for the destination MAC
162  *		Indicates that this data type frame is not encrypted even if
173  *		Indicates that at least one of the rx buffers has been
178  *		Indicates that the MPDU was pre-maturely terminated
183  *		Indicates that the MPDU Michael integrity check failed
186  *		Indicates that the MPDU decrypt integrity check failed
189  *		Indicates that the MPDU FCS check failed
192  *		If set indicates that the RX packet data, RX header data, RX
212  *		Indicates the number of more buffers associated with RX DMA
216  *		Indicates the number of more buffers associated with RX DMA
220  *		Indicates the number of more buffers associated with RX DMA
224  *		Indicates the number of more buffers associated with RX DMA
302  *		Indicates type of decrypt cipher used (as defined in the
375  *		Indicates that this is the last MPDU of a PPDU.
378  *		Indicates that a delimiter FCS error occurred after this
489  *		Indicates the IP offset in bytes from the start of the
494  *		Indicates the destination RX rings for this MSDU.
497  *		Indicates the offset in bytes to the start of TCP or UDP
500  *		indicates that the offset is longer than 127 bytes.
518  *		Indicates the MSDU number within a MPDU.  This value is
523  *		Indicates the format after decapsulation:
530  *		Set if L2 layer indicates IPv4 protocol.
533  *		Set if L2 layer indicates IPv6 protocol.
537  *		protocol indicates TCP.
541  *			protocol indicates UDP.
544  *		Indicates that either the IP More frag bit is set or IP frag
545  *		number is non-zero.  If set indicates that this is a
635  *		Indicates the number classification filter rule
660  *		Indicates the first MSDU of A-MSDU.  If both first_msdu and
666  *		Indicates the last MSDU of the A-MSDU.  MPDU end status is
670  *		Indicates that the MSDU threshold was exceeded and thus
679  *		Indicates that the first delimiter had a FCS failure.  Only
741  *		Value of 0x80 indicates invalid.
745  *		Value of 0x80 indicates invalid.
749  *		Value of 0x80 indicates invalid.
753  *		Value of 0x80 indicates invalid.
757  *		Value of 0x80 indicates invalid.
761  *		Value of 0x80 indicates invalid.
765  *		Value of 0x80 indicates invalid.
769  *		Value of 0x80 indicates invalid.
773  *		Value of 0x80 indicates invalid.
777  *		Value of 0x80 indicates invalid.
781  *		Value of 0x80 indicates invalid.
785  *		Value of 0x80 indicates invalid.
789  *		Value of 0x80 indicates invalid.
793  *		Value of 0x80 indicates invalid.
797  *		Value of 0x80 indicates invalid.
801  *		Value of 0x80 indicates invalid.
805  *		bandwidths.  Value of 0x80 indicates invalid.
836  *		Legacy signal rate select.  If set then l_sig_rate indicates
837  *		CCK rates.  If clear then l_sig_rate indicates OFDM rates.
849  *		Indicates the type of preamble ahead:
878  *		Indicates that the packet data carries H information which
1221  *		Indicates a PHY error was detected for this PPDU.
1224  *		Indicates that location information was requested.
1227  *		Indicates that the packet data carries H information which
1237  *		Indicates that a HT or VHT Ack/BA frame was transmitted in
1241  *		Indicates that the BB has captured a channel dump.  FW can
1251  *		Indicates the number of bytes of baseband information for
1253  *		which indicates that this is not a normal PPDU but rather