Lines Matching +full:reg +full:- +full:names
8 reg = <0x80000000 0x10000000>; /* 256 MB */
12 pinctrl-names = "default";
13 pinctrl-0 = <&wl12xx_gpio>;
18 vdds_dsi-supply = <&vpll2>;
19 vdda_video-supply = <&lcd_3v3>;
20 pinctrl-names = "default";
21 pinctrl-0 = <
28 pinctrl-names = "default";
29 pinctrl-0 = <&ehci_phy_pins>;
33 pinctrl-names = "default";
34 pinctrl-0 = <&on_board_gpio_61 &hsusb2_pins>;
37 pinctrl-single,pins = <
66 pinctrl-single,pins = <
82 pinctrl-single,pins = <
97 pinctrl-single,pins = <
103 /* Devices are routed with gpmc_nbe1.gpio_61 to on-board devices */
105 pinctrl-single,pins = <
112 pinctrl-single,pins = <
139 pinctrl-single,pins = <
146 pinctrl-single,pins = <
154 pinctrl-single,pins = <
166 pinctrl-names = "default";
167 pinctrl-0 = <&mmc1_pins>;
171 pinctrl-names = "default";
172 pinctrl-0 = <&mmc2_pins>;
180 interrupts-extended = <&intc 72 &omap3_pmx_core OMAP3_UART1_RX>;
184 interrupts-extended = <&intc 73 &omap3_pmx_core OMAP3_UART2_RX>;
188 interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
189 pinctrl-names = "default";
190 pinctrl-0 = <&uart3_pins>;
194 * GPIO_61 (nUSB2_EN_1V8) must be low to enable on-board EHCI USB2 interface
195 * for bus switch SN74CB3Q3384A, level-shifter SN74AVC16T245DGGR, and 1.8V.
199 gpio-hog;
201 output-low;
202 line-name = "enable usb2 port";
206 /* T2_GPIO_2 low to route GPIO_61 to on-board devices */
209 gpio-hog;
211 output-low;
212 line-name = "en_hsusb2_clk";
221 pinctrl-names = "default";
222 pinctrl-0 = <&smsc911x_pins>;