boot/dts/omap3-devkit8000-common.dtsi

1 // SPDX-License-Identifier: GPL-2.0-only
6 #include <dt-bindings/input/input.h>
16 		compatible = "gpio-leds";
20 			gpios = <&gpio6 26 GPIO_ACTIVE_HIGH>;	/* 186 -> LED1 */
21 			default-state = "on";
22 			linux,default-trigger = "heartbeat";
27 			gpios = <&gpio6 3 GPIO_ACTIVE_HIGH>;	/* 163 -> LED2 */
28 			default-state = "on";
29 			linux,default-trigger = "none";
34 			gpios = <&gpio6 4 GPIO_ACTIVE_HIGH>;	/* 164 -> LED3 */
35 			default-state = "on";
36 			linux,default-trigger = "usr";
41 			gpios = <&twl_gpio 19 GPIO_ACTIVE_HIGH>; /* LEDB */
46 		compatible = "ti,omap-twl4030";
50 		ti,audio-routing =
58 		compatible = "gpio-keys";
62 			gpios = <&gpio1 26 GPIO_ACTIVE_HIGH>;
64 			wakeup-source;
70 		powerdown-gpios = <&twl_gpio 7 GPIO_ACTIVE_LOW>;
73 			#address-cells = <1>;
74 			#size-cells = <0>;
80 					remote-endpoint = <&dpi_dvi_out>;
88 					remote-endpoint = <&dvi_connector_in>;
95 		compatible = "dvi-connector";
100 		ddc-i2c-bus = <&i2c2>;
104 				remote-endpoint = <&tfp410_out>;
110 		compatible = "svideo-connector";
115 				remote-endpoint = <&venc_out>;
122 	clock-frequency = <2600000>;
129 			compatible = "ti,twl4030-audio";
137 	clock-frequency = <400000>;
148 	vmmc-supply = <&vmmc1>;
149 	vqmmc-supply = <&vsim>;
150 	bus-width = <8>;
162 	ti,use-leds;
205 		compatible = "ti,omap2-nand";
207 		interrupt-parent = <&gpmc>;
210 		nand-bus-width = <16>;
211 		gpmc,device-width = <2>;
212 		ti,nand-ecc-opt = "sw";
214 		gpmc,sync-clk-ps = <0>;
215 		gpmc,cs-on-ns = <0>;
216 		gpmc,cs-rd-off-ns = <44>;
217 		gpmc,cs-wr-off-ns = <44>;
218 		gpmc,adv-on-ns = <6>;
219 		gpmc,adv-rd-off-ns = <34>;
220 		gpmc,adv-wr-off-ns = <44>;
221 		gpmc,we-off-ns = <40>;
222 		gpmc,oe-off-ns = <54>;
223 		gpmc,access-ns = <64>;
224 		gpmc,rd-cycle-ns = <82>;
225 		gpmc,wr-cycle-ns = <82>;
226 		gpmc,wr-access-ns = <40>;
227 		gpmc,wr-data-mux-bus-ns = <0>;
229 		#address-cells = <1>;
230 		#size-cells = <1>;
232 		x-loader@0 {
233 			label = "X-Loader";
238 			label = "U-Boot";
243 			label = "U-Boot Env";
262 		bank-width = <2>;
263 		interrupt-parent = <&gpio1>;
265 		davicom,no-eeprom;
267 		gpmc,mux-add-data = <0>;
268 		gpmc,device-width = <1>;
269 		gpmc,wait-pin = <0>;
270 		gpmc,cycle2cycle-samecsen = <1>;
271 		gpmc,cycle2cycle-diffcsen = <1>;
273 		gpmc,cs-on-ns = <6>;
274 		gpmc,cs-rd-off-ns = <180>;
275 		gpmc,cs-wr-off-ns = <180>;
276 		gpmc,adv-on-ns = <0>;
277 		gpmc,adv-rd-off-ns = <18>;
278 		gpmc,adv-wr-off-ns = <48>;
279 		gpmc,oe-on-ns = <54>;
280 		gpmc,oe-off-ns = <168>;
281 		gpmc,we-on-ns = <54>;
282 		gpmc,we-off-ns = <168>;
283 		gpmc,rd-cycle-ns = <186>;
284 		gpmc,wr-cycle-ns = <186>;
285 		gpmc,access-ns = <144>;
286 		gpmc,page-burst-access-ns = <24>;
287 		gpmc,bus-turnaround-ns = <90>;
288 		gpmc,cycle2cycle-delay-ns = <90>;
289 		gpmc,wait-monitoring-ns = <0>;
290 		gpmc,clk-activation-ns = <0>;
291 		gpmc,wr-data-mux-bus-ns = <0>;
292 		gpmc,wr-access-ns = <0>;
298 		pinctrl-single,pins = <
333 	regulator-name = "vdds_dsi";
335 	regulator-min-microvolt = <1800000>;
336 	regulator-max-microvolt = <1800000>;
342 	pinctrl-names = "default";
343 	pinctrl-0 = <&dss_dpi_pins>;
345 	vdds_dsi-supply = <&vpll1>;
346 	vdda_dac-supply = <&vdac>;
349 		#address-cells = <1>;
350 		#size-cells = <0>;
353 			remote-endpoint = <&tfp410_in>;
354 			data-lines = <24>;
366 	vdda-supply = <&vdac>;
370 			remote-endpoint = <&tv_connector_in>;