Lines Matching full:default
11 - 0 - disabled (default)
17 parameters to their default state (RFC1122 for hosts, RFC1812
21 Default value of TTL field (Time To Live) for outgoing (but not
23 Default: 64 (as recommended by RFC1700)
49 Default: FALSE
52 default 552 - minimum discovered Path MTU
55 By default we don't trust protocol path MTUs while forwarding
63 Default: 0 (disabled)
76 Default: 0
84 Default: 0 (disabled)
95 Default: 0 (Layer 3)
107 Default: 512kB Minimum: 64kB Maximum: 64MB
114 Default: 1 (Update priority.)
128 neigh/default/gc_thresh1 - INTEGER
132 Default: 128
134 neigh/default/gc_thresh2 - INTEGER
139 Default: 512
141 neigh/default/gc_thresh3 - INTEGER
146 Default: 1024
148 neigh/default/unres_qlen_bytes - INTEGER
155 Default: SK_WMEM_MAX, (same as net.core.wmem_default).
161 neigh/default/unres_qlen - INTEGER
167 Prior to linux 3.3, the default value is 3 which may cause
168 unexpected packet loss. The current default value is calculated
169 according to default value of unres_qlen_bytes and true size of
172 Default: 101
216 Default: 64
249 reset them. Default state is FALSE. It means that if overflow
262 Default: 1
269 Default is "reno" and the default setting (tcp_congestion_control).
275 Default: 31
286 Default : 1
302 Default : 48
311 Default : 48 (at least 8 bytes of payload per segment)
317 Default is set as part of kernel configuration.
336 Default: 3
355 Default: 2
365 Default: 1 (fallback enabled)
380 Default: 60 seconds
389 By default it's enabled with a non-zero value. 0 disables F-RTO.
400 Default: 0
422 Default: 500 (milliseconds).
426 Default: 2hours.
430 connection is broken. Default value: 9.
435 after probes started. Default value: 75sec i.e. connection
446 Default: 0 (disabled)
458 if network conditions require more than default value,
483 if network conditions require more than default value.
508 Default: 300
514 default.
521 - 1 - Disabled by default, enabled when an ICMP black hole detected
526 Discovery reprobe. The default is reprobing every 10 minutes as
531 will stop in respect to the width of search range in bytes. Default
535 By default, TCP saves various connection metrics in the route cache
545 Default is 1, which disables ssthresh metrics.
552 The default value is 8.
572 Default: 0x1
579 Default: 3
586 Default: 300
600 default.
609 The default value of 15 yields a hypothetical timeout of 924.6
622 Default: 0
624 tcp_rmem - vector of 3 INTEGERs: min, default, max
629 Default: 4K
631 default: initial size of receive buffer used by TCP sockets.
633 Default: 87380 bytes. This value results in window of 65535 with
634 default setting of tcp_adv_win_scale and tcp_app_win:0 and a bit
635 less for default tcp_app_win. See below about these variables.
642 Default: between 87380B and 6MB, depending on RAM size.
650 The default is 1ms, based on TSO autosizing period.
652 Default : 1,000,000 ns (1 ms)
660 Default : 100,000 ns (100 us)
666 Default : 44
674 Default: 1
681 Default: FALSE
685 be retransmitted. Should not be higher than 255. Default value
694 Default: 1
719 The client support is enabled by flag 0x1 (on by default). The client
723 The server support is enabled by flag 0x2 (off by default). Then
739 default without explicit TCP_FASTOPEN socket option.
742 Default: 0x1
755 By default, it is set to 1hr.
779 will be retransmitted. Should not be higher than 127. Default value
792 Default: 1
803 Default: 2
812 Default: 200
820 Default: 120
828 Default: 3
841 Default: 2
846 tcp_wmem - vector of 3 INTEGERs: min, default, max
850 Default: 4K
852 default: initial size of send buffer used by TCP sockets. This
857 Default: 16K
865 Default: between 64K and 4MB, depending on RAM size.
878 Default: UINT_MAX (0xFFFFFFFF)
886 Default: 0
899 Default: 0
911 Default: 1048576 (16 * 65536)
916 Default: 1000
924 Default: 0 (disabled)
936 Default: 0 (disabled)
949 Default is calculated at boot time from amount of available memory.
956 Default: 4K
963 Default: 4K
975 Default: 1 (enabled)
987 Default: 1
997 Default: 10
1005 Default: 0
1015 Default: 0
1027 The default values are 32768 and 60999 respectively.
1058 Default: Empty
1067 Default: 1024
1073 Default: 0
1076 By default, bind() does not select the ports automatically even if
1082 Default: 0
1090 Default: 0
1100 Default: 1
1104 The default is "1 0", meaning, that nobody (not even root) may
1112 Default: 1
1118 Default: 1
1124 Default: 0
1130 Default: 1
1140 Default: 1000
1148 Default: 1000
1155 Default: 50
1162 Default mask: 0000001100000011000 (6168)
1182 .. [1] These are rate limited by default (see default mask above)
1190 Default: 1
1207 Default: 0
1211 Default: 20
1235 Default: 10
1240 Default: 2 (as specified by RFC2236 8.1)
1245 - 0 - (default) No enforcement of a IGMP version, IGMPv1/v2 fallback
1252 - 3 - Enforce to use IGMP version 3. The same react with default 0.
1259 this value as default 0 is recommended.
1288 default:
1307 The default value 0 means that the device is the only interface
1350 default TRUE
1363 default TRUE
1372 Default: TRUE
1381 default FALSE
1390 default
1399 default FALSE
1405 default FALSE
1412 By default failed packets are discarded.
1425 Default value is 0. Note that some distributions enable it
1436 - 0 - (default) The kernel can respond to arp requests with addresses
1452 - 0 - (default) Use any local address, configured on any interface
1483 - 0 - (default): reply for any local target IP address, configured
1502 0 (default): do nothing
1549 Default: 10000 (10 seconds)
1555 Default: 1000 (1 seconds)
1567 1122, but is disabled by default for compatibility reasons.
1569 Default: off (0)
1576 Default: off (0)
1582 Default value is 0.
1594 Default TRUE
1616 Default value for IPV6_V6ONLY socket option,
1623 Default: FALSE (as specified in RFC3493)
1633 Default: TRUE
1643 1 automatic flow labels are enabled by default, they can be
1652 Default: 1
1662 Default: true
1684 Default: 0
1689 Default: 0 (Layer 3)
1704 Default: FALSE
1711 Default: 1 (as specified in RFC7217)
1717 Default: 3 (as specified in RFC7217)
1722 Default: 2 (as specified by RFC3810 9.1)
1732 Default: 8
1740 Default: 8
1746 Default: INT_MAX (unlimited)
1752 Default: INT_MAX (unlimited)
1757 generate this message; IPv6 does by default. Setting this sysctl
1761 Default: false (generate message)
1766 default which means route dumps and notifications contain the new
1773 Default: true (backward compat mode)
1802 Default is 0.
1804 ``conf/default/*``:
1805 Change the interface-specific default settings.
1833 Default: 0
1858 Functional default:
1864 Learn default router in Router Advertisement.
1866 Functional default:
1875 Default is to NOT accept these as it may be an un-intended
1878 Functional default:
1891 Default: 1
1896 Functional default:
1907 Functional default:
1918 Functional default:
1926 Functional default:
1935 Functional default:
1943 Functional default:
1954 Default: 0
1960 Functional default:
1968 Default: 1
1985 By default, Host behaviour is assumed. This means:
1988 2. If accept_ra is TRUE (default), transmit Router
1990 3. If accept_ra is TRUE (default), accept Router
1992 4. If accept_redirects is TRUE (default), accept Redirects.
2004 Default: 0 (disabled) if global forwarding is disabled (default),
2008 Default Hop Limit to set.
2010 Default: 64
2013 Default Maximum Transfer Unit
2015 Default: 1280 (IPv6 required minimum)
2021 Default: 0
2027 Default: 60
2033 Default: 1
2038 Default: 4
2044 Default: 3
2051 Default: false
2062 Default:
2070 Default: 172800 (2 days)
2075 Default: 86400 (1 day)
2082 * 0 : system default
2085 Default: 0 (addresses are removed)
2093 Default: 600
2099 Default: 5
2107 Default: 16
2114 Default: FALSE (enable IPv6 operation)
2130 1 Enable DAD (default)
2142 Default: FALSE
2160 * 0 - (default): do nothing
2165 The IPv6 Traffic Class to use by default when sending IPv6 Neighbor
2172 * 0 - (default)
2178 Default: 10000 (10 seconds)
2184 Default: 1000 (1 second)
2187 * 0 - (default) No enforcement of a MLD version, MLDv1 fallback allowed
2195 * 1 - (default) discard fragmented neighbor discovery packets
2201 * 0: disabled (default)
2214 * 0: disabled (default)
2224 be stable privacy ones by default. This can be changed via the
2225 addrgenmode ip-link. conf/default/stable_secret is used as the
2232 By default the stable secret is unset.
2238 0 generate address based on EUI64 (default)
2250 By default this is turned off.
2257 By default this is turned off.
2267 Default: TRUE
2278 Default: 1000
2293 Default: 0-1,3-127 (rate limit ICMPv6 errors except Packet Too Big)
2299 Default: 0
2305 Default: 0
2311 Default: 0
2332 Default: 1
2338 Default: 1
2344 Default: 1
2350 Default: 0
2356 Default: 0
2368 Default: 0
2383 Default: 0
2402 Default: 1
2424 Default: 0
2444 Default: 0
2455 Default: 0
2464 Default: 1
2470 Default: 4
2477 Default: 10
2484 Default: 8
2492 Default: 5
2508 Default: 0
2517 is disabled by initializing 'ps_retrans' per netns as 0xffff by default,
2520 Default: 0xffff
2527 Default: 3000
2533 Default: 60000
2539 Default: 1000
2546 Default: 30000
2552 Default: 200
2555 The default lifetime of the SCTP cookie (in milliseconds). The cookie
2558 Default: 60000
2567 Default: 1
2582 Default: Dependent on configuration. MD5 if available, else SHA1 if
2599 Default: 0
2607 Default: 0
2620 Default is calculated at boot time from amount of available memory.
2622 sctp_rmem - vector of 3 INTEGERs: min, default, max
2623 Only the first value ("min") is used, "default" and "max" are
2630 Default: 4K
2632 sctp_wmem - vector of 3 INTEGERs: min, default, max
2643 Default: 1
2658 Default: 10