Lines Matching full:backup

173 	(active-backup, balance-alb and balance-tlb).  Possible values
332 	backup or 2
334 		Validation is performed only for backup slaves.
353 		only for backup slaves.
362 	that they were generated by an arp_ip_target.  Since backup slaves
364 	for backup slaves is on the broadcast ARP request sent out via the
366 	configurations may result in situations wherein the backup slaves
368 	of backup slaves must be disabled.
370 	The validation of ARP requests on backup slaves is mainly helping
373 	backup slave will work if it's selected as the next active slave.
409 	This option affects only active-backup mode for slaves with
435 	Specifies whether active-backup mode should set all slaves to
445 		bonding to set all slaves of an active-backup bond to
483 		to this MAC address while they are in a backup role; a
565 	active-backup or 1
567 		Active-backup policy: Only one slave in the bond is
574 		occurs in active-backup mode, bonding will issue one
722 	affect only the active-backup mode.  These options were added for
757 	The primary option is only valid for active-backup(1),
969 	This option is useful for bonding modes balance-rr (0), active-backup
1087 	BONDING_MODULE_OPTS="mode=active-backup miimon=100"
1245   BONDING_OPTS="mode=active-backup arp_interval=60 arp_ip_target=192.168.1.254"
1561 active-backup mode, using ARP monitoring, add the following lines to
1566 	echo active-backup > /sys/class/net/bond1/bonding/mode
1592 active-backup mode, with eth0 and eth1 as slaves::
1597 		bond-mode active-backup
1609 		bond-mode active-backup
1650 	Bonding Mode: fault-tolerance (active-backup)
1705 output slave selection was limited to round-robin and active-backup modes.
1831 The active-backup, balance-tlb and balance-alb modes do not
2155 For the active-backup, balance-tlb and balance-alb modes, the
2165 For the active-backup, balance-tlb and balance-alb modes, when
2173 maximum network availability by having redundant or backup devices,
2223 In a topology such as the example above, the active-backup and
2228 active-backup:
2232 	a backup switch (e.g., has lower capacity, higher cost, etc),
2394 active-backup:
2396 	the active-backup mode, as the inactive backup devices are all
2400 	available bandwidth.  On the plus side, active-backup mode
2419 	Like active-backup, there is not much advantage to this
2582 switches take a long time to go into backup mode, it may be desirable
2583 to not activate a backup interface immediately after a link goes down.
2599 For example, on a bond in active-backup mode with five slaves
2642 balance-rr, active-backup, balance-tlb and balance-alb modes.  This is
2708 The active-backup mode has no additional requirements.
2756 slaves in active-backup mode.
2774 disabled.  The active-backup mode will fail over to a backup link, and
2817 The active-backup mode should work with any Layer-II switch.