net/dsa/ocelot.txt

5 -----
9 - VSC9959 (Felix)
10 - VSC9953 (Seville)
12 The VSC9959 switch is found in the NXP LS1028A. It is a PCI device, part of the
13 larger ENETC root complex. As a result, the ethernet-switch node is a sub-node
18   in this case for the Ethernet L2Switch it is PF5 (of device 0, bus 0).
22 The interrupt line is used to signal availability of PTP TX timestamps and for
25 For the external switch ports, depending on board configuration, "phy-mode" and
26 "phy-handle" are populated by board specific device tree instances. Ports 4 and
30 the Ocelot hardware core. The CPU port in Ocelot is a set of queues, which are
32 By default, in fsl-ls1028a.dtsi, the NPI port is assigned to the internal
34 use case.  Moving the NPI port to an external switch port is hardware possible,
35 but there is no platform support for the Linux system on the LS1028A chip to
37 tagging) is supported on a single port at a time.
39 Any port can be disabled (and in fsl-ls1028a.dtsi, they are indeed all disabled
40 by default, and should be enabled on a per-board basis). But if any external
41 switch port is enabled at all, the ENETC PF2 (enetc_port2) should be enabled as
42 well, regardless of whether it is configured as the DSA master or not. This is
46 Supported PHY interface types (appropriate SerDes protocol setting changes are
53 * phy_mode = "2500base-x": on ports 0, 1, 2, 3
64 	pcie@1f0000000 { /* Integrated Endpoint Root Complex */
65 		ethernet-switch@0,5 {
71 				#address-cells = <1>;
72 				#size-cells = <0>;
99 					phy-mode = "internal";
101 					fixed-link {
103 						full-duplex;
107 				/* Non-tagging CPU port */
110 					phy-mode = "internal";
113 					fixed-link {
115 						full-duplex;
123 The VSC9953 switch is found inside NXP T1040. It is a platform device with the
126 - compatible:
127 	Must be "mscc,vsc9953-switch".
129 Supported PHY interface types (appropriate SerDes protocol setting changes are
139 	ethernet-switch@800000 {
140 		#address-cells = <0x1>;
141 		#size-cells = <0x0>;
142 		compatible = "mscc,vsc9953-switch";
143 		little-endian;
147 			#address-cells = <0x1>;
148 			#size-cells = <0x0>;
192 				phy-mode = "internal";
195 				fixed-link {
197 					full-duplex;
203 				phy-mode = "internal";
206 				fixed-link {
208 					full-duplex;