Lines Matching full:panel

4 $id: http://devicetree.org/schemas/display/panel/panel-common.yaml#
18   When referenced from panel device tree bindings the properties defined in this
19   document are defined as follows. The panel device tree bindings are
36       The label property specifies a symbolic name for the panel as a
43       non-descriptive information. For instance an LCD panel in a system that
44       contains a single panel shall not be labelled "LCD" if that name is not
55   panel-timing:
58       require specific display timings. The panel-timing subnode expresses those
60     $ref: panel-timing.yaml#
77       the nature of those connections is specific to the panel type, the
92       This panel is supposed to communicate that it's ready via HPD
94       hardcode the max delay from the panel spec when powering up the panel.
105   # and timing of those control signals are device-specific and left for panel
112       Specifier for a GPIO connected to the panel enable control signal. The
113       enable signal is active high and enables operation of the panel. This
119       Note that the enable signal control panel operation only and must not be
125       Specifier for a GPIO connected to the panel reset control signal.
126       The reset signal is active low and resets the panel internal logic
141       more than one power supply with panel-specific constraints governing the
143       supply is sufficient, either because the panel has a single power rail, or
145       the power-supply property specifies the supply powering the panel as a