Lines Matching +full:host +full:- +full:wake

13 	These commands are used to configure the host sleep parameters::
14 	bit 8:0  -- Gap
15 	bit 16:8 -- GPIO
17 	where GPIO is the pin number of GPIO used to wake up the host.
18 	It could be any valid GPIO pin# (e.g. 0-7) or 0xff (SDIO interface
22 	wakeup event, or 0xff for special host sleep setting.
26 		# Use SDIO interface to wake up the host and set GAP to 0x80:
30 		# Use GPIO pin #3 to wake up the host and set GAP to 0xff:
39 			1 	-- Enable auto sleep mode
40 			0 	-- Disable auto sleep mode
54 	These commands are used to enable host sleep or wake up firmware
58 			1	-- Enable host sleep
59 			0	-- Wake up firmware
63 		# Enable host sleep
67 		# Wake up firmware
90 	This command display the host sleep state.
106 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x00    --Enable All interface
107 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x01    --Enable Wlan interface
108 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x02    --Enable BT interface
109 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x00    --Disable All interface
110 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x01    --Disable Wlan interface
111 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x02    --Disable BT interface
118 - /lib/firmware/sd8688_helper.bin
119 - /lib/firmware/sd8688.bin
124 git.infradead.org/users/dwmw2/linux-firmware.git/libertas/