Lines Matching full:counter

1 What:		/sys/bus/counter/devices/counterX/countY/count
7 What:		/sys/bus/counter/devices/counterX/countY/ceiling
12 		respective counter.
14 What:		/sys/bus/counter/devices/counterX/countY/floor
19 		respective counter.
21 What:		/sys/bus/counter/devices/counterX/countY/count_mode
36 			to the Count Y floor value. The counter freezes at
43 			The counter is disabled whenever a counter overflow or
44 			underflow takes place. The counter is re-enabled when a
45 			new count value is loaded to the counter via a preset
50 			value and the Count Y ceiling value. The counter is
52 			counting up, while the counter is set to the Count Y
54 			counter does not freeze at the boundary points, but
57 What:		/sys/bus/counter/devices/counterX/countY/count_mode_available
58 What:		/sys/bus/counter/devices/counterX/countY/error_noise_available
59 What:		/sys/bus/counter/devices/counterX/countY/function_available
60 What:		/sys/bus/counter/devices/counterX/countY/signalZ_action_available
68 What:		/sys/bus/counter/devices/counterX/countY/direction
75 		Some counter devices are able to determine the direction of
81 What:		/sys/bus/counter/devices/counterX/countY/enable
85 		Whether channel Y counter is enabled. Valid attribute values are
89 		for Count Y. Suppose a counter device is used to count the total
91 		to temporarily pause the counter, service the conveyor belt,
92 		and then finally unpause the counter to continue where it had
95 What:		/sys/bus/counter/devices/counterX/countY/error_noise
100 		present at the channel Y counter inputs.
102 What:		/sys/bus/counter/devices/counterX/countY/function
149 What:		/sys/bus/counter/devices/counterX/countY/name
157 What:		/sys/bus/counter/devices/counterX/countY/preset
161 		If the counter device supports preset registers -- registers
162 		used to load counter channels to a set count upon device-defined
166 What:		/sys/bus/counter/devices/counterX/countY/preset_enable
170 		Whether channel Y counter preset operation is enabled. Valid
173 What:		/sys/bus/counter/devices/counterX/countY/signalZ_action
196 What:		/sys/bus/counter/devices/counterX/name
201 		the Counter. This should match the name of the device as it
204 What:		/sys/bus/counter/devices/counterX/num_counts
209 		belonging to the Counter.
211 What:		/sys/bus/counter/devices/counterX/num_signals
216 		belonging to the Counter.
218 What:		/sys/bus/counter/devices/counterX/signalY/signal
224 What:		/sys/bus/counter/devices/counterX/signalY/name