Lines Matching full:at

27  *             consecutively numbered gpios beginning at the given base,
33  *                output-only GPO pin will be added at the end of the block.
35  *                 for each IO line in the expander.  Setting the bit at
36  *                 position n will enable the pull-up for the IO at
41  *                 bit at position n will enable the pull-down for the IO at
46  *                     bit at position n enables open-drain operation for
47  *                     the IO at the corresponding offset.  Clearing the bit
52  *               in the expander.  Setting the bit at position n inverts
62  * @irq_base: The first 'virtual IRQ' line at which our block of GPIO-based
64  *            will create a block of irqs beginning at this number.
67  *                      reset of the chip at the beginning of the probe