Lines Matching +full:0 +full:x2000
10 #define DATAPORT 0x0000
11 #define WRITE_PTR 0x0002
12 #define READ_PTR 0x0004
13 #define SIGNAL_CA 0x0006
14 #define SET_IRQ 0x0007
15 #define SM_PTR 0x0008
16 #define MEM_Dec 0x000a
17 #define MEM_Ctrl 0x000b
18 #define MEM_Page_Ctrl 0x000c
19 #define Config 0x000d
20 #define EEPROM_Ctrl 0x000e
21 #define ID_PORT 0x000f
22 #define MEM_ECtrl 0x000f
29 #define SIRQ_en 0x08
30 #define SIRQ_dis 0x00
33 #define EC_Clk 0x01
34 #define EC_CS 0x02
35 #define EC_Wr 0x04
36 #define EC_Rd 0x08
37 #define ASIC_RST 0x40
38 #define i586_RST 0x80
47 #define SCP_START 0xfff6
50 #define ISCP_START 0x0000
53 #define SCB_START 0x0008
61 #define TX_BUF_START 0x0100
63 #define TX_BUF_SIZE ((24+ETH_FRAME_LEN+31)&~0x1f)
64 #define RX_BUF_SIZE ((32+ETH_FRAME_LEN+31)&~0x1f)
71 #define SCB_complete(s) (((s) & 0x8000) != 0)
72 #define SCB_rxdframe(s) (((s) & 0x4000) != 0)
73 #define SCB_CUdead(s) (((s) & 0x2000) != 0)
74 #define SCB_RUdead(s) (((s) & 0x1000) != 0)
75 #define SCB_ack(s) ((s) & 0xf000)
77 /* Command unit status: 0=idle, 1=suspended, 2=active */
78 #define SCB_CUstat(s) (((s)&0x0300)>>8)
80 /* Receive unit status: 0=idle, 1=suspended, 2=out of resources, 4=ready */
81 #define SCB_RUstat(s) (((s)&0x0070)>>4)
84 #define SCB_CUnop 0x0000
85 #define SCB_CUstart 0x0100
86 #define SCB_CUresume 0x0200
87 #define SCB_CUsuspend 0x0300
88 #define SCB_CUabort 0x0400
89 #define SCB_resetchip 0x0080
91 #define SCB_RUnop 0x0000
92 #define SCB_RUstart 0x0010
93 #define SCB_RUresume 0x0020
94 #define SCB_RUsuspend 0x0030
95 #define SCB_RUabort 0x0040
101 #define Stat_Done(s) (((s) & 0x8000) != 0)
102 #define Stat_Busy(s) (((s) & 0x4000) != 0)
103 #define Stat_OK(s) (((s) & 0x2000) != 0)
104 #define Stat_Abort(s) (((s) & 0x1000) != 0)
105 #define Stat_STFail (((s) & 0x0800) != 0)
106 #define Stat_TNoCar(s) (((s) & 0x0400) != 0)
107 #define Stat_TNoCTS(s) (((s) & 0x0200) != 0)
108 #define Stat_TNoDMA(s) (((s) & 0x0100) != 0)
109 #define Stat_TDefer(s) (((s) & 0x0080) != 0)
110 #define Stat_TColl(s) (((s) & 0x0040) != 0)
111 #define Stat_TXColl(s) (((s) & 0x0020) != 0)
112 #define Stat_NoColl(s) ((s) & 0x000f)
121 #define Cmd_END 0x8000
122 #define Cmd_SUS 0x4000
123 #define Cmd_INT 0x2000
125 #define Cmd_Nop 0x0000
126 #define Cmd_SetAddr 0x0001
127 #define Cmd_Config 0x0002
128 #define Cmd_MCast 0x0003
129 #define Cmd_Xmit 0x0004
130 #define Cmd_TDR 0x0005
131 #define Cmd_Dump 0x0006
132 #define Cmd_Diag 0x0007
139 #define FD_Done(s) (((s) & 0x8000) != 0)
140 #define FD_Busy(s) (((s) & 0x4000) != 0)
141 #define FD_OK(s) (((s) & 0x2000) != 0)
143 #define FD_CRC(s) (((s) & 0x0800) != 0)
144 #define FD_Align(s) (((s) & 0x0400) != 0)
145 #define FD_Resrc(s) (((s) & 0x0200) != 0)
146 #define FD_DMA(s) (((s) & 0x0100) != 0)
147 #define FD_Short(s) (((s) & 0x0080) != 0)
148 #define FD_NoEOF(s) (((s) & 0x0040) != 0)
179 #define TDR_TIME 0x7ff