Lines Matching full:3

6 This document describes the usage and errata of the 3Com "Vortex" device
7 driver for Linux, 3c59x.c.
23 3c575-series Cardbus cards which used to be handled by 3c575_cb.c.
27 	3c590 Vortex 10Mbps
28 	3c592 EISA 10Mbps Demon/Vortex
29 	3c597 EISA Fast Demon/Vortex
30 	3c595 Vortex 100baseTx
31 	3c595 Vortex 100baseT4
32 	3c595 Vortex 100base-MII
33 	3c900 Boomerang 10baseT
34 	3c900 Boomerang 10Mbps Combo
35 	3c900 Cyclone 10Mbps TPO
36 	3c900 Cyclone 10Mbps Combo
37 	3c900 Cyclone 10Mbps TPC
38 	3c900B-FL Cyclone 10base-FL
39 	3c905 Boomerang 100baseTx
40 	3c905 Boomerang 100baseT4
41 	3c905B Cyclone 100baseTx
42 	3c905B Cyclone 10/100/BNC
43 	3c905B-FX Cyclone 100baseFx
44 	3c905C Tornado
45 	3c920B-EMB-WNM (ATI Radeon 9100 IGP)
46 	3c980 Cyclone
47 	3c980C Python-T
48 	3cSOHO100-TX Hurricane
49 	3c555 Laptop Hurricane
50 	3c556 Laptop Tornado
51 	3c556B Laptop Hurricane
52 	3c575 [Megahertz] 10/100 LAN  CardBus
53 	3c575 Boomerang CardBus
54 	3CCFE575BT Cyclone CardBus
55 	3CCFE575CT Tornado CardBus
56 	3CCFE656 Cyclone CardBus
57 	3CCFEM656B Cyclone+Winmodem CardBus
58 	3CXFEM656C Tornado+Winmodem CardBus
59 	3c450 HomePNA Tornado
60 	3c920 Tornado
61 	3c982 Hydra Dual Port A
62 	3c982 Hydra Dual Port B
63 	3c905B-T4
64 	3c920B-EMB-WNM Tornado
73 options 3c59x debug=3 rx_copybreak=300
78 module "3c59x" opts "debug=3 rx_copybreak=300"
85   Where N is a number from 0 to 7.  Anything above 3 produces a lot
91   network card.  So if you have two 3c905's and you wish to provide
103 	3	10base2 (BNC)
123     insmod 3c59x options=0x204
130   Sets the `options' parameter for all 3c59x NICs in the machine. 
145   Sets full duplex mode for all 3c59x NICs in the machine.  Entries
150   Use 802.3x MAC-layer flow control.  The 3com cards only support the
157   This feature does not appear to work on the 3c905 - only 3c905B and
158   3c905C have been tested.
160   The 3com cards appear to only respond to PAUSE frames which are
188   Recent 3com NICs are able to generate IPv4, TCP and UDP checksums
237   Sets enable_wol mode for all 3c59x NICs in the machine.  Entries in
243 A number of the older NICs such as the 3c590 and 3c900 series have
255 	modprobe 3c59x options=0
269 As a last resort, you can force the 3c59x driver into full-duplex mode
272 	options 3c59x full_duplex=1
304 3Com's DOS-based application for setting up the NICs EEPROMs:
306 	ftp://ftp.3com.com/pub/nic/3c90x/3c90xx2.exe
376      eth0: 3Com PCI 3c905C Tornado at 0xa400,  00:50:da:6a:88:f0, IRQ 19
377      8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
384 	modprobe 3c59x debug=2
388      00:09.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74)
389              Subsystem: 3Com Corporation: Unknown device 9200
434       3) Download you card's diagnostic tool from Donald