Documentation/networking/arcnet-hardware.txt

251 SETTING THE JUMPERS
452 (IRQ Setting)		      IRQ2  IRQ3 IRQ4 IRQ5 IRQ7
463                 WARNING.  It's very important when setting these which way
471 			Setting		Value
479 			Setting		Value
495 			Setting		Value
514 			Setting		Value
606 Setting one of the switches to Off/Open means "1", On/Closed means "0".
609 Setting the Node ID
617 Setting the I/O Base Address
637 Setting the Base Memory (RAM) buffer Address
693 Setting the Timeouts and Interrupt
814 Setting one of the switches to Off/Open means "1", On/Closed means "0".
817 Setting the Node ID
858 Setting the I/O Base Address
901 Setting the Interrupt
922 Setting the Timeouts
1192         are in a weird order.  This was tested by setting the DIP switches,
1331 Setting one of the switches to Off means "1", On means "0".
1334 Setting the Node ID
1374 Setting the I/O Base Address
1394 Setting the Base Memory (RAM) buffer Address
1422 Setting the Interrupt Line
1437 Setting the Internal Terminator on CN120AB/TP/SBT
1468 Setting the Timeout Parameters
1541 Setting one of the switches to Off means "1", On means "0".
1544 Setting the Node ID
1584 Setting the I/O Base Address
1606 Setting the Base Memory (RAM) buffer Address
1623 Setting the Interrupt Line
1649 Setting the Timeout Parameters
1808 Setting the Node ID
1815 Setting one of the switches to OFF means "1", ON means "0".
1834 Setting the I/O Base Address
1855 Setting the Base Memory (RAM) buffer Address
1875 Setting the Interrupt Line
1949 Setting the Node ID
1956 Setting one of the switches to Off means "1", On means "0".
1973 Setting the I/O Base Address
1993 Setting the Base Memory (RAM) buffer Address
2018 Setting the Interrupt Line
2033 Setting the Timeout Parameters
2090 Setting the Node ID
2097 Setting one of the switches to Off means "1", On means "0".
2113 Setting the I/O Base Address
2133 Setting the Base Memory (RAM) buffer Address
2158 Setting the Interrupt Line
2174 Setting the Timeout Parameters
2432 Setting one of the switches to Off means "1", On means "0".
2435 Setting the Node ID
2476 Setting the I/O Base Address
2495 Setting the Base Memory (RAM) buffer Address
2551 Setting Interrupt Request Lines (IRQ)
2558 Setting the Timeouts
2621 Setting one of the switches to Off means "1", On means "0".
2624 Setting the Node ID
2665 Setting the I/O Base Address
2684 Setting the Base Memory (RAM) buffer Address
2737 Setting Interrupt Request Lines (IRQ)
2743 Setting the Timeouts
2800 Setting the jumpers to ON means connecting the upper two pins, off the bottom
2801 two - or - in case of IRQ setting, connecting none of them at all.
2803 Setting the Node ID
2810 Setting one of the switches to Off means "1", On means "0".
2845 Setting the I/O Base Address
2865 Setting the Base Memory (RAM) buffer Address
2889 Setting the Interrupt Line
2904 Setting the Timeout Parameters
2978 Setting the I/O Base Address
2998 Setting the Base Memory Address (RAM & ROM)
3020 Setting the Node ID