Lines Matching +full:power +full:- +full:domains
15 Andigilog has both the PECI and pre-PECI versions of the Heceta-6, as
16 Intel calls them. Heceta-6e has high frequency PWM and Heceta-6p has
18 Heceta-6e part and aSC7621 is the Heceta-6p part. They are both in
23 have used registers below 20h for vendor-specific functions in addition
24 to those in the Intel-specified vendor range.
27 The fan speed control uses this finer value to produce a "step-less" fan
28 PWM output. These two bytes are "read-locked" to guarantee that once a
29 high or low byte is read, the other byte is locked-in until after the
32 sheet says 10-bits of resolution, although you may find the lower bits
42 We offer GPIO features on the former VID pins. These are open-drain
60 PECI Extended configuration allows for having more than two domains per
64 Intel configuration. This would be useful in multi-CPU systems with
69 fan types. We can also support pulse-stretched PWM so that 3-wire fans
73 measurement system for individual tachs in order to save power. That is
76 --
80 Using a 10-bit ADC, the aSC7621 measures the temperature of two remote diode
90 temperature zones. Both high- and low-frequency PWM ranges are supported.
101 System voltages of VCCP, 2.5V, 3.3V, 5.0V, and 12V motherboard power are
105 - Supports PECI interface and monitors internal and remote thermal diodes
106 - 2-wire, SMBus 2.0 compliant, serial interface
107 - 10-bit ADC
108 - Monitors VCCP, 2.5V, 3.3V, 5.0V, and 12V motherboard/processor supplies
109 - Programmable autonomous fan control based on temperature readings
110 - Noise filtering of temperature reading for fan speed control
111 - 0.25C digital temperature sensor resolution
112 - 3 PWM fan speed control outputs for 2-, 3- or 4-wire fans and up to 4 fan
114 - Enhanced measured temperature to Temperature Zone assignment.
115 - Provides high and low PWM frequency ranges
116 - 3 GPIO pins for custom use
117 - 24-Lead QSOP package
123 the standards defined in "sysfs-interface".
167 temp[1-4]_smoothing_enable
168 temp[1-4]_smoothing_time
180 temp[1-4]_crit
184 temp[5-8]_input
185 temp[5-8]_enable
191 pwm[1-3]_enable
198 4-254 Ignored.
201 pwm[1-3]_auto_channels
202 Bitmap as described in sysctl-interface with the following
220 pwm[1-3]_invert
221 When set, inverts the meaning of pwm[1-3].
225 pwm[1-3]_freq
289 0 1 or 2 Domains for enabled processors (default)
290 1 3 or 4 Domains for enabled processors
296 1 Processor contains two domains (0,1)