bindings/mtd/fsl-upm-nand.txt

4 - compatible : "fsl,upm-nand".
5 - reg : should specify localbus chip select and size used for the chip.
6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
10 - fsl,upm-wait-flags : add chip-dependent short delays after running the
13 - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
15 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
16 	(R/B#). For multi-chip devices, "n" GPIO definitions are required
18 - chip-delay : chip dependent delay for transferring data from array to
25 	compatible = "fsl,upm-nand";
27 	fsl,upm-addr-offset = <16>;
28 	fsl,upm-cmd-offset = <8>;
32 		#address-cells = <1>;
33 		#size-cells = <1>;
43 	#address-cells = <0>;
44 	#size-cells = <0>;
45 	compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand";
47 	fsl,upm-addr-offset = <0x10>;
48 	fsl,upm-cmd-offset = <0x08>;
49 	/* Multi-chip NAND device */
50 	fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
51 	fsl,upm-wait-flags = <0x5>;
52 	chip-delay = <25>; // in micro-seconds
55 		#address-cells = <1>;
56 		#size-cells = <1>;